Jamberry Nail Shields are designed to be easily applied in a salon or at home.
Step 1: Clean nails with nail polish remover or alcohol.
Step 2: Cut and file nails to desired length and shape.
Step 3: Buff top of the nail, clean once more with nail polish remover or alcohol, and push back cuticle.
Step 4: Match nail (finger or toe) to the nail shield that best fits.
Step 5: Peel off nail shield and warm with a blow-dryer 10-15 seconds or until soft and flexible.
Step 6: When warm, press the shield onto the nail. Apply firm pressure around edges to adhere the shield to the nail. Use rubber cuticle pusher to seal the shield around the cuticle.
Step 7: Trim the top with scissors and file off remaining shield using a downward motion to remove excess.
Step 8: Apply heat and pressure to the shield again until it is sealed to the nail. (Repeating this step several times helps create a tight seal to the nail surface and increases wear time)
How to remove:
There are 2 removal options for Jamberry Nail Shields. For Nail Shields that have
been worn for more than 10 days we recommend following the Gentle Removal Process.
Quick Removal Process: Heat the shields with a blowdryer for 15 seconds.
Then break the seal by getting under the edge of the shield with your opposite thumb
nail. Slowly peel the shield from side to side. If the Nail Shields are not peeling
easily or the adhesive is still bonded to the nail bed then follow the Gentle Removal
Gentle Removal Process:
Soak the Nail Shields in nail polish remover for
20-30 seconds and gently rub them off. Soaking will break down the adhesive bond
and allow them to easily slide of the nail bed.